4 5
How to use the juicer
Assembly / Operation / Disassembly
3
Put pulp container into the juicer cover
outlet as shown in the drawing and
then push it until it locks into the juicer
base . Juice may leak out or excessive
vibration may occur when it’s not
tted properly.
1
Put juicing bowl on the base and
insert juicing screen rmly into the
base as shown below.
2
Put juicer cover on the juicing bowl
and push safety locking arm rmly
inward on both sides of the base
until you hear them ‘click’ as
shown below.
4
Please wait 3-5 seconds after
turning the unit on before
inserting produce.
Push LOW button
to make natural juice with soft fruits like
watermelon, peeled oranges, etc.
Push TURBO botton
to make natural juice with hard fruits and
vegetables like apples, carrots, celery, etc.
How to assemble How to operate
How to disassemble
.
For safety, always make sure the unit is unplugged before assembly or disassembly.
.
When assembling the juicer, the parts must be in alignment or the arms will not lock.
.
Check that the parts are aligned before locking the arms. If the parts are not aligned as
shown in the manual, forcing the arms shut may cause damage!
.
For best results slowly feed large or hard ingredients with the pusher in 2-3 stages,
alternating between pushing and pausing. This technique ensures the maximum
amount of juice extraction and also prevents malfunction.
1
Turn the machine o and unplug the
power cord from the wall outlet. Pull out
the safety locking arm to disassemble.
Tips
2
Follow the assembly steps in reverse
to disassemble.
Remove the juicing screen
after disassembling the
juicing bowl from the base.
To Next Page
Loading...
