Need help?Do you have a question about the KuWFi CPE70R and is the answer not in the manual?
General| Brand | KuWFi |
|---|---|
| Model | CPE70R |
| Category | Network Hardware |
| Language | English |
Visual representation of the KuWFi Point-to-Point Bridge product.
Details the 10/100Mbps RJ45 WAN and LAN ports on the device.
Describes the LED display and the Function/Select buttons for control.
Explains the reset button for default settings and LED configuration.
Guides on setting the CPE mode to Master or Slave using a switch.
Steps to configure the master CPE using buttons for pairing.
Instructions for establishing a point-to-point connection via reset button.
Explains LED codes (e.g., H005/C005) for channel and IP address.
Explains LED codes for WiFi signal and pairing status.
Guides on accessing and modifying network adapter settings in Windows.
Steps for setting up TCP/IP properties for the CPE connection.
Instructions for assigning a static IP address to the PC for communication.
How to access the CPE's web interface using a browser.
Default username and password for logging into the web interface.
Describes extending WiFi signal coverage between two locations.
Describes using CPEs for wireless video transmission with cameras.
Guidance on setting the optimal distance between CPE units (500M-1000M).
How to connect the CPE's WAN port to an IP camera.
Connecting the client CPE's LAN to POE adapter, WAN to camera.
Connecting the master CPE's LAN to POE adapter, WAN to router.
Requirements for face-to-face installation and same height alignment.
Steps to connect cameras, CPEs, and NVR/DVR for video transmission.
Describes a point-to-point setup for elevator monitoring systems.
Describes a point-to-multi-point setup for general monitoring.
Details WDS, multi-point, and wireless coverage topologies.
To Next Page