Kval 994-X - Page 7

Table of Contents
Kval 994-X Operation Manual
Step 1: Hinge Carriage Calibration.......................................................3-9
Step 2: Router Calibrations.................................................................3-12
Step 3: Pre-Drill Calibration ................................................................3-13
Step 4: (Option CH) Chisel Calibration...............................................3-15
Calibration of the Back Section................................................ 3-17
Lock Location Calibration ...................................................................3-17
Fast and Slow Lock Plate Timing........................................................3-18
Option SB: CNC Back Section Calibration .........................................3-19
Chapter 4 Tour of the 994-X
Operator’s Tour ........................................................................ 4-2
Options Available..................................................................................4-2
The 994-X will:......................................................................................4-2
Machine Component Terms..................................................... 4-3
Overview of Machine ............................................................... 4-4
994-X with Standard Hoppers...............................................................4-4
994-X with RTS Hoppers ......................................................................4-5
About the RTS Rotary Hopper..............................................................4-6
Basic Operation of the RTS ..................................................................4-7
Operator Controls .................................................................... 4-8
Operator’s Station.................................................................................4-8
Machine Control....................................................................................4-9
Door/Jamb Foot Pedal........................................................................4-10
About the In-Feed Section....................................................... 4-11
Door Stops..........................................................................................4-12
Setting Jamb Stop and Jamb Height ..................................................4-12
About the Front Section ........................................................... 4-13
About the Hinge Carriage ........................................................ 4-14
Option CR: Counter Rotate Router.....................................................4-15
Option CH: Added Chisels..................................................................4-16
About the Six/Eight Shooter System........................................ 4-17
Option K: Eight Shooter......................................................................4-18
About the Six/Eight Shooter Controls .................................................4-19
About the Hopper..................................................................... 4-20
Driver Assembly..................................................................................4-22
Option: Quick Change Knuckle Assembly ..........................................4-23
About the Over-Head Track ..................................................... 4-24
About the Back Section: .......................................................... 4-25