Need help?Do you have a question about the Kybota LA1153 and is the answer not in the manual?
Procedures for dealers to assemble and adjust the product before delivery.
Essential safety guidelines to prevent accidents during assembly and operation.
Steps for unpacking the loader from its wooden crate.
Verifying all loader components are included after unpacking.
Adjusting front and rear tread widths for stability and component longevity.
Instructions for installing the tool box on CAB model tractors.
Steps to install the main frames to the tractor's clutch housing and front axle.
Attaching the valve stay support for ROPS and CAB models.
Connecting hydraulic lines for Type 1 tractor PTO configurations.
Connecting hydraulic lines for Type 2 tractor PTO configurations.
Fitting controller stays, installing levers, and routing cables.
Securing the valve cover to the valve stay.
Assembling the valve stay and attaching the self-level valve.
Preparing and installing the accumulator assembly with orifice.
Connecting hydraulic hoses and accumulator for the 3rd function.
Detaching the loader and connecting the multi coupler assembly.
Preparing the lever boot and control lever for installation.
Routing and connecting the control lever wire harness.
Attaching the quick hitch frame and the bucket to the loader.
Connecting hydraulic hoses to the control valve and checking for leaks.
Lubricating grease fittings and checking transmission fluid.
Estimated time required for loader assembly.
Torque values for various bolts and nuts.
Guide for using the template to cut the rubber mat for the controller cable.
To Next Page
General