Channel setting in your code plug for analog APRS
For test make one analog channel And name it APRS ANA.
Put correct RX and TX frequency
Move slider to the right and under APRS choose APRS(A)
NOTE: analog APRS will work only on analog channels!
Channels settings in code plug for Digital APRS
NOTE: in Europe digital APRS is allowed to transmit only on TS2!
On your digital channel, at the end on the right side under the APRS column just choose 1, that mean current channel.
WARNING: Firmware is not finish yet so Digital APRS will transmit and proper work only on TS2,
DO NOT CHOOSE Digital APRS to work on TS1, because IT WILL NOT WORK and you will make a unnecessary traffic on TS1!
NOTE2: Digital APRS will work only on digital channels!
We are working very hard to fix that in the future.
To Previous Page