Kyocera ECOSYS M6026 - Page 5

Projekt CAMPUS dB
Technical Documentation
Kyocera ECOSYS M6026/M6526cidn
FRA AI/M-D
Author(s): Dirk Czichon
File: CdBTD_Kyocera_EcoSys-M6026M6526cidn.doc
Signed off by:
Manuel Siefker
Version: 1.0
Page 5 of 6
Valid from: 05.07.2014
Vorlage 14.07.2004
Scroll and select “IP-Address”, set according to order xx.xxx.xxx.xxx
Scroll and select “Subnet Mask”, set according to order 255.255.xxx.xxx
Scroll and select “Default Gateway”, set according to order xx.xxx.xxx.x
Leave this level “ < ”
Scroll and select “IPv6 Settings” see Page 9-20
Scroll and select “IPv6”, if not allready set to OFF
Scroll and select “RA (Statless)”, if not allready set to OFF
Scroll and select “DHCP”, if not allready set to OFF
Leave this level “ < ”
Scroll and select “Bonjour”, if not allready set to OFF
Scroll and select “Protocol Detail” see Page 9-21
Scroll and select “NetBEUI”, if not allready set to OFF
Scroll and select “SNMP”, if not allready set to ON
Scroll and select “SNMPv3”, if not allready set to OFF
Scroll and select “RAW Port”, if not allready set to ON
Scroll and select “WSD Scan”, if not allready set to OFF see Page 9-22
Scroll and select “WSD Print”, if not allready set to OFF
Scroll and select “Enhanced WSD”, if not allready set to OFF
Scroll and select “Enhanced WSD (SSL)”, if not allready set to OFF
Leave this level “ < ”
Leave this level “ < ”
Leave this level “ < ”
Scroll and select Date/Time/Energy Saver see Page 9-27
Scroll and select “Low Power Timer”, if not allready set to 15 Min
Scroll and select “Sleep Level”, if not allready set to Quick Recovery
Scroll and select “Sleep Rules” if this point exists; if not skip
Scroll and select “Network”, if not allready set to OFF
Scroll and select “FAX”, if not allready set to OFF
Leave this level “ < ”
Scroll and select “Sleep Timer”, if not allready set to 15 Min
Leave this level “ < ”