To Next PageTo Next PageWhy is the measured value unstable on my KYOWA PCD-300B?
If the measured value of your KYOWA Recording Equipment (PCD-300B) is unstable, it might be due to external noise interference. Ensure the input adapter and cable are correctly connected and secured. Also, verify the ground cable is properly connected to minimize noise.
What to do if the measured value is faulty on KYOWA PCD-300B?
If you are getting faulty readings from your KYOWA Recording Equipment, ensure that the gage and connection methods are correct, and that cables are correctly connected. Also, make sure the ground cable is connected.
How to turn on KYOWA Recording Equipment when the power lamp is off?
If your KYOWA Recording Equipment is not powering on, check if the correct voltage is being supplied to the AC power plug. Ensure that the AC adapter input/output plug is securely connected and that the power switch is fully turned on.
What to do if KYOWA PCD-300B Recording Equipment stops and won't respond?
If your KYOWA Recording Equipment (PCD-300B) stops and becomes unresponsive, it may be due to external noise. Try turning the power on again. If the issue persists, implement noise countermeasures for the operating environment and power supply.
What does 'NG' mean on the self-test of KYOWA Recording Equipment?
If your KYOWA Recording Equipment displays 'NG' during the self-test, power cycle the device and run the self-check again. If the issue persists, it may be due to external noise. Take steps to reduce noise from the environment and power supply. If the problem continues, the device may be damaged, and you should contact KYOWA or its representatives.
What to do if the power lamp flickers on KYOWA PCD-300B Recording Equipment?
If the power lamp on your KYOWA Recording Equipment is flickering, immediately stop using the equipment and contact KYOWA or their representative.
Provides instructions for safe operation and user responsibilities.
Explains WARNING and CAUTION symbols used in the manual.
Explains panel face notation using parenthesis.
Describes special notations for attention and reference information.
Introduces the PCD-300B as a USB-connected measuring instrument for strain measurement.
Details PC, USB cable, AC adapter, USB hub, and software requirements.
Describes the front panel components and their functions.
Details the rear panel components and their functions with different input adapters.
Explains how to connect the AC adapter and check voltage for safe operation.
Details how to connect a DC power supply and voltage range.
Explains how to set the PCD Number using the front panel switch.
Describes the features and compatibility of different input adapters.
Details connection methods for various gages and input adapters.
Provides step-by-step instructions for connecting wires to specific input terminals.
Explains how to mount and demount input adapters using jackscrews.
Guides on connecting multiple PCD-300B units using synchronous cables.
Details connecting the PCD-300B to a PC via USB, including hub usage.
Explains how to operate the power switch and notes on startup.
Directs users to install the USB driver from the provided manual.
Describes how to perform and interpret the self-test.
Provides formula for measuring value compensation with different gage factors.
Explains how to compensate for errors introduced by extension cables.
Defines technical terms like Wheatstone Bridge, Gage Method, Gage Factor, etc.
Lists the detailed technical specifications of the PCD-300B.
Shows external dimensions and component layout of PCD-300B units.
General| Brand | KYOWA |
|---|---|
| Model | PCD-300B |
| Category | Recording Equipment |
| Language | English |
