91
Operating Instructions:
1. STOP! Read the safety information provided.
2. Depress and turn valve clockwise to “OFF” position and
temperature indicator to the lowest setting.
3. Turn off all electric power to the appliance.
4. Wait five minutes for propane to clear the area. If you smell
propane, STOP! Follow previous instructions, What To Do If
You Smell propane. If you do not smell propane, go to next step.
5. Depress and turn the propane valve counterclockwise to
“PILOT” position, press down and light the pilot, hold down until
pilot remains lit.
6. Depress and turn the propane valve counterclockwise to “ON”
position.
7. If the pilot goes out, repeat steps two through six. On initial
start-up, this may take several times in order to purge the air
from the propane lines.
8. Turn valve to “ON” position and main burners will light to heat
water.
9. Set the temperature dial to desired setting.
10. Test water before bathing or showering.
PILOT FLAME
Temperature
Dial
Gas Valve
Temperature setting on the control was factory set at the lowest setting to
reduce risk of scald injury. Setting the temperature dial past the low position
will increase the risk of scald injury. Children, disabled, elderly and diabet-
ics are at highest risk of being scalded.
CAUTION
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
