L.A. Spas 2010 North American User Manual (English)

Questions and Answers:

C
Christina WatersAug 13, 2025
Why is my L.A. Spas 2010 North American Hot Tub water cold?
- S
  Seth MoralesAug 13, 2025
  There are several reasons why your L.A. Spas hot tub water might be cold. It could be that the temperature setting is lower than you expect due to a power reset. In this case, increase the temperature. Alternatively, the spa might be in economy mode, so reset it to standard mode. Other potential causes include dirty filters (clean them), an air lock (prime the pump), or closed jets obstructing the flow (open the jets). If none of these solutions work, it could be an equipment malfunction, and you should call for service.
L
Louis JohnsonAug 16, 2025
Why is my L.A. Spas Hot Tub water too warm?
- G
  Grace JohnsonAug 17, 2025
  Your L.A. Spas hot tub might be overheating because the temperature setting is too high; try decreasing it. Another reason could be too much filtration, so reduce the number of filter cycles or their duration. Dirty filters can also cause this issue, so clean them. If the problem persists, it could be due to an overheat or high limit occurrence or an equipment malfunction, in which case you should call for service.
D
David RodriguezAug 20, 2025
What to do if my L.A. Spas Hot Tub will not turn on?
- M
  millerlisaAug 20, 2025
  If your L.A. Spas hot tub isn't turning on, first check the circuit breaker and/or GFCI to ensure there is power. If there is power, and the control panel is unresponsive, try turning the power off to the spa and then back on. If the control panel still isn't working, or if an overheat has occurred, it's best to call for service.