STEP 3. JACK HARDWARE INSTALLATION
Insert the end of the jack through the hole in the
L-bracket (see gure 4), and hold in place while you
thread on the end cap (see gure 5). Hold the
barrel with one hand as you grip the end cap with
your other hand, using the round gripping pad
provided, and tighten until each side is ush with
the L-bracket. Hand tight is sucient, no tools
required. Tie down loose wires with the provided
zip ties and wire clips.
PERFORMANCE RECOMMENDATION
The Banjo Pickup is a high impedance, passive
transducer and will perform best with an external,
acoustic preamp.
g. 4
g. 5
To Next Page
Loading...