Need help?Do you have a question about the L.R. Baggs LR Baggs ACOUSTIC DI and is the answer not in the manual?
General| Frequency Response | 20Hz - 20kHz |
|---|---|
| Power Supply | 9V battery or 48V phantom power |
| Inputs | 1 x 1/4" instrument |
| Outputs | 1 x XLR Balanced Output, 1 x 1/4" (6.35mm) Unbalanced Output |
| Features | Ground Lift |
| Power | 9V Battery or Phantom Power |
| Input Impedance | 10 MΩ |
| Output Impedance | 600 ohms (balanced), 3k ohms (unbalanced) |
| Phantom Power | Yes |
Very low bass, almost felt as much as heard.
Helps with feedback problems and can be used as an EQ knob for tone shaping.
Adjusts upper warmth frequencies to nasal range. Useful for warmth or reducing nasal quality.
Affects 'sss' sounds, cymbal sizzle, and brightness. Useful for removing PA horn glare.
Controls the very highest frequencies for 'air' or 'frosting'.
Indicates unit status and low battery. Flashes when battery reaches 6 volts.
Controls the output signal level without affecting tone. Recommended to run high for best signal-to-noise.
Provides quick and easy battery changes for continuous operation.
Standard, post EQ/effects, balanced low impedance output for PA systems.
Alerts to the presence of 48V phantom power with a green light.
Unbalanced output for standard mono cables, same signal as XLR for routing flexibility.
Changes signal polarity to minimize low-end feedback or affect mix with other instruments.
Send-return jack for outboard effects, allows blending external effects with the dry signal.
Adjusts input amplification level. Refer to 'Setting the Gain' section for usage.
Input for guitar or mic. Preamp turns on when plugged in. Note 'pop' reduction.
Register the Para DI online at Irbaggs.com/product-registration.
Warrants product free of defects for one year. Contact dealer for issues.
To Next Page
