La Crosse Technology LTV-TH1 - User Manual

Model: LTV-TH1
DC: 083017
Thermo-hygro Sensor
Power & Mounting
1. Install 2-AA batteries according to polarity and replace battery cover. The blue LED light will flash
when transmitting.
Mounting:
1. Use the hole at the top to hang your sensor from the back using a nail. Or, insert one mounting screw
through the front of your sensor.
2. Mount your sensor on a north-facing wall or in any shaded area. Under an eave or deck rail is
preferred to avoid inaccurate readings from the sun.
3. The maximum wireless transmission range to the weather station is up to 400 feet (121 meters) in open
air, not including walls or floors.
4. Be sure your sensor is mounted vertically, to allow moisture to drain out properly.
Note: Watch sensor mounting video: http://bit.ly/TH_SensorMounting
Hole for
mounting
LED Light
AA
+
-
AA
+
-
Battery Cover
TX
∙ Press TX to
send a signal
TX

Summary

Power & Mounting

Battery Installation

Install 2-AA batteries according to polarity and replace the battery cover. The blue LED will flash when transmitting.

Mounting Instructions

Describes methods for hanging the sensor using a hole or screw, preferred locations, and vertical orientation for drainage.

Sensor ID and Pairing

Sensor ID Overview

Explains the sensor's bar code and ID number for locking into a station or recognized by the La Crosse View™ app.

Adding to La Crosse View System

Step-by-step guide to add the sensor to an existing La Crosse View™ system via the app.

Social Media Engagement

Customer Feedback and Support

Product Specifications

Warranty and Support

FCC Compliance

La Crosse Technology LTV-TH1 Specifications

General

Brand	La Crosse Technology
Model	LTV-TH1
Category	Temperature Controller
Language	English