02
Initial Setup
Power Up
Note: It may take up to 10 minutes for your sensor data to appear on your
station’s screen.
BASICS
Weather Station
Insert the 5V Power Adapter into an outlet, and then plug it into the Power Jack on the back of
the station. Next, remove the Insulation Tab from the Station’s Battery Compartment.
Thermo-Hygro Sensor
Install 2 fresh “AA” batteries according to polarity and replace battery cover. The blue LED light
will flash when transmitting.
Back of Station
(V15)
Thermo-Hygro Sensor
(LTV-TH5i)
Power Jack
To Next Page
Loading...
