21
EN
Before connecting the water softener to
the machine, carry out a washing cycle
until the water is clear and then connect
the water softener to the machine.
Connect the drip tray (G) to the drain conduit (B).
If the mains water pressure is higher than 0.5 Mpa
(5 bar), it is recommended to install a balanced
pressure regulator for high pressures (a device
that prevents an increase in supply pressure from
a ecting the output pressure).
3–2. ELECTRICAL CONNECTION
Before connecting the machine to the
power supply, make sure that the voltage
is the same as that indicated on the CE
plate.
Make sure that the mains supply is suitable for
the power requirements of the machine. Connect
to an earth socket that complies with current
regulations. Make sure that the power cable
is working correctly and that it complies with
national and European safety regulations.
The user is responsible for installing a suitable
safety switch (circuit breaker) on the power line to
the machine according to the regulations in force
in the country of use.
Connect the power cable (I) to the power line
using an all-pole circuit breaker (D) with a contact
separation distance of at least 3 mm to provide
complete disconnection in category III overvoltage
conditions.
To change voltage, please refer to the diagram on
the box of the main switch.
It is compulsory to connect the yellow/
green cable to the earthing system of the
premises.
The machine is tted with an equipotential
bonding terminal under the drip tray next to the
following symbol The terminal can be used to
connect power cables from 2.5 mm to 6 mm. Use
the cable lug supplied with the machine to make
the connection.
The single-phase connection of the
co ee machine is only allowed in
premises that have an electrical
system with an impedance adequate
for the adsorbed current of the
appliance.
4. MACHINE DESCRIPTION
1. ON / OFF switch
2. Heater switch
3. Hot water nozzle
4. Hot water button
5. Group head
6. Filter holder
7. Drip tray
8. Drip tray grid
9. Front panel
10. Data plate
11. Dual scale pressure gauge
12. Steam nozzle
13. Steam tap knob
14. Front panel
15. Group head control
16. Cup warmer shelf
17. Co ee cup rest
18. Cup warmer illuminated switch
5. STARTING THE MACHINE FOR THE FIRST
TIME
• Once the hydraulic and electrical connections
have been completed, the machine can be
started up. Open the water tap (A).
• Turn o the circuit breaker (D).
• Press the power on button (1); the power on light
will come on.
• The automatic water level device will start
>
100A
WATER MAINS
CONNECTION
NON-
RETURN
VALVE
MACHINE
CONNECTION
FROM COFFEE
To Next Page
Loading...
Need help?
General
