La Spaziale RAPID - Page 44

INSTRUCTIONMANUALFORTHEINSTALLER



  



Holddownthebutton
ofthersttouchpadontheright(1stGROUP)foraboutuntil
theLEDsofthecontrolpanelswitchon(21-20-19-18).
Pressthecupwarmerbutton(24)andcheckthattheLEDindicatingcupwarmerstatus(23)andtheLED
ofthe1stgroup(21)haveswitchedonindicatingtheprocessofenteringthehotwaterdoseprogramming
phase.Atthisstage,thewatertemperaturemixoptionisdeactivated.
Pressthecupwarmerbutton(24)againtoactivatethetemperaturemixsetting;the4thLEDfromtheright
willswitchontoindicatethismode.
Insummary:
 Led1stgroupon(21)=nomixedwater
 Led4thgroupon(18)=50%hotwaterand50%coldwater.

Proceedtothehotwaterdoseprogrammingphaseasfollows:
• Placeapitcherbelowthehotwaternozzle(7),soastoavoidanypossibleburns.
• Pressthehotwaterbutton(6)tostarthotwaterdelivery.
• Oncetherequireddosehasbeendelivered,pressthebutton(6)againtostopthedelivery.



Pressthecupwarmeroperatingbutton(24)andcheckitsoperatingstatusthroughthelightingupofthe
LED(23)onthecontrolpanel.Toswitchitoff,pressthesamebutton.




