To Next PageTo Next Page
Need help?Do you have a question about the Labkotec SandSET-1000 12 VDC and is the answer not in the manual?
General| Brand | Labkotec |
|---|---|
| Model | SandSET-1000 12 VDC |
| Category | Test Equipment |
| Language | English |
Details the indicators, buttons, and connectors on the SandSET-1000 12 VDC control unit.
Instructions for wall-mounting the SandSET-1000 12 VDC control unit enclosure.
Guidance on how to install the SET/S2 sensor in tanks or separators.
Information on connecting sensor cables using the LCJ1-SK4 cable joint.
Procedure to test the alarm device's operation after installation.
Describes normal, alarm, fault, and reset states of the SandSET-1000 12 VDC.
Details on adjusting device settings using switches and potentiometers.
Diagnosing problems when the MAINS LED indicator is off.
Troubleshooting when alarms fail to trigger or clear properly.
Resolving faults indicated by the FAULT LED.
Procedures for cleaning and servicing the sensor and control unit.
Safety precautions for installations in potentially explosive environments.
Detailed specifications for the SandSET-1000 12 VDC control unit.
Specifications for the SET/S2 sensor, including electrical parameters.
Table of permissible electrical values for explosion groups IIC and IIB.
