- 3 -
● If the power cable or terminal is damaged, stop using it and contact a service center.
-There is a risk of electric shock, or injury.
● Do not bend the power cable excessively or press it with heavy objects to prevent damage.
-There is a risk of electric shock, or injury.
● Do not touch the circuit breaker or power source with wet hands.
-There is a risk of electric shock, or fire
● Please be sure to ground for safety.
- If not, there is a risk of electric shock in case of malfunction or short circuit
● Be sure to check the rated voltage when installing
- 220/230 V ~, 50 or 60 Hz, single phase.
- If the voltage or rating does not match, it may cause fire or electric shock, and if used in
combination with other equipment, it may cause abnormal heat generation and fire.
● The figures, diagrams and numeric values used in this manual are only for the purpose of
illustration.
● DAIHAN LABTECH CO., LTD. is not responsible for any damage or injury that is caused as a result
of using this equipment, equipment failure of indirect damage.
● No portion of this document may be reprinted, copied, stored, and retrieved through any
electronic, optical or other means without prior written approval from DAIHAN LABTECH CO.,
LTD.
● Your equipment are 220/230V~, 50 or 60 Hz, SINGLE PHASE.
● To reduce the risk of electric shock, do not open the body and no user serviceable parts inside.
● Do not put flammable, volatile or explosive materials inside of the chamber.
To Next Page
Loading...
Need help?
General
