Plate warmer cabinet (option SULLY 1800 and SULLY 2200)
Plate warmer-insulated stainless internal lining (AISI 304). Heating provided by 950 W heating element underneath
base. Controlled by thermostat selector switch, 30 to 110 °C. Capacity: 72 plates, Ø 240 mm (9.5’’). Dimensions D x W
x H: 530 mm (20.8’’) x 325 mm (12.8’’) x 490 mm (19.3’’). 5 shelf level with 68 mm (2.8’’).
Rating: 1030 W – Power supply: 240 Volts 60Hz
Accessories:
Per oven: One drip tray, one rack, one pastry tray per oven.
Shipment-Packaging:
Unpack and check the appliance is in good condition. In case damage, note any reservations on the delivery note and
confirm them within 48 hours by registered letter with confirmation of delivery to the carrier.
200 kg /180 kg – 445 / 400 lb
275 kg /245 kg – 605 / 540 lb
350 kg /310 kg – 770 / 685 lb
Gas connection:
1/2” ID NPT (Sch 40) inlet, on male coupling (Figures 1 & 2). Sealant on all pipe joints must be resistive to LP gas.
If used, a flex gas line for the gas supply must be metal of at least 1/2” ID NPT approved by an approved certifying
agency (A.G.A., C.G.A., etc.) in compliance with ANSI Z21.41 and Z21.69. Never use a hose made of rubber or other
synthetic material.
Gas supplying:
Appliance gas supplying can be switched, please refer to rating plate and marking at the rear of the appliance.
Electrical connection:
On terminal block at the rear of the appliance. Use flexible cord in accordance with standard N.E.C., AINSI/NEMA 70-
1996 or latest edition (not cord provided) (Figures 1 & 2).
Pressures and hourly consumption:
Appliance gas supplying can be switched (table 1).
Ultra fast (UF) Tradition (T)
To Next Page
Loading...
