Lafalink PW100 User Manual

300Mbps Inwall
Wireless Repeater
Quick Installation Guide
300Mbps Inwall
Wireless Repeater
Quick Installation Guide
Hardware and Operation Mode
LED and Interface
PowerWLANEthernetSystem
Gateway Mode
Access Point Mode
Repeater Mode
AP Mode AP Mode
AP MODE
Repeater MODE
Router/Switch
Operation Mode
Gateway
Router/Switch
Installation Steps
Hardware Connection
Setting the Computer
Log in the Web Management
Setting the AP
Test the Wireless Network
Install the AP to the Wall
Note:
1. Before Install the AP on the wall, you would
better complete the software setting.
2. Before the setting of the AP, you would better
complete the design of Topology of network
and IP address the devices.
Hareware Conection
Setting the Repeater through Wireless
Setting the AP using Wireless
Plug the Wireless Repeater to the Outlet, and using wireless to connect the repeater
(SSID：CQ300, Key:66666666), and then log the 192.168.0.1 to setting the Repeater
using the IE Browser.
and then log the 192.168.0.1 to setting the
AP using the IE Browser.
Plug the Wireless Repeater to the Outlet, and using wires connect to the repeater
Hardware Connection
Inwall Repeater
Inwall Repeater
Setting the Repeater through Wires with RJ45 Cable
Setting the AP using Wires
As belows shows.
Setting the Computer
Setting the AP through Wireless
same network segment as AP,subnet mask 255.255.255.0
the default Passwords is"66666666"
CQ300
ZHH
segment as the AP
subnet mask 255.255.255.0 As belows shows.
Setting the AP through Wires with RJ45 Cable
1
2 3
WAN/LAN Ethernet Port
Micro USB Port for Power
WPS Button
Power Plug

Lafalink PW100 Specifications

General

Model	PW100
Category	Repeater
Frequency Band	2.4GHz
Maximum Wireless Speed	300 Mbps
Ports	1 x 10/100Mbps Ethernet Port
Weight	100g
Wireless Standard	802.11n
Security	WPA/WPA2
Operating Mode	Repeater, AP
Antenna	2 x External Antennas

Summary

Hardware and Operation Mode

LED and Interface Overview

Details the LED indicators and physical interfaces of the wireless repeater.

Wireless Repeater Operation Modes

Explains the different operational modes: Gateway, Access Point, and Repeater.

Quick Installation Steps

Hardware Connection Setup

Guides on connecting the wireless repeater, either via wireless or RJ45 cable.

Computer Configuration

Instructions for setting up the computer's IP address for repeater configuration.

Web Management Login

Steps to access and log into the repeater's web management interface.

Access Point Configuration

Details on configuring the repeater for Gateway, Repeater, or AP modes.

Wireless Network Testing

Procedure to test the functionality of the wireless network after setup.

Final AP Wall Installation

Guidance on physically installing the access point to a wall.

Using the WPS Button

WPS Button Pairing Procedure

Explains how to use the WPS button for easy wireless bridging and signal extension.

Troubleshooting Common Issues

Login and Network Connectivity Solutions

Provides solutions for forgotten credentials, login failures, and connectivity problems.

Wireless Network Configuration Fixes

Addresses issues related to SSID/password loss and mobile/PC internet access.

Power Indicator Troubleshooting

Guidance on resolving issues when the power indicator light is not active.