Lafayette DUO2 DVB-S - Page 26

DUO2- user’s manual user’s manual - DUO2
47
48
3.4 SAT/MP Manager
It has three options
• Satellite Setting
• Auto Scan
• Transponder
3.4.1 Satellite Setting
In the all Satellites Setting:
Press blue key to clear all selecte of satellite.
Press orange key to selecte all satellites.
Press green key into auto scan interface.
Press red key into the Transponder interface.
Press key to move the cursor, then press ok key to change the satellite select or unselect.
In the setting interface:
1– TP Manage: press red key into TP manager.
2– Auto Scan: press green key into auto scan.
3– LNB: Press
key then change the LNB frequency.
4– Transponder: Press key then change the current TP.
5– DiSEqc1.0: Press key to change the DiSEqC port.
6– DiSEqc1.1: Press key to change the DiSEqC port.
7– Motor: Press key to change the DiSEqC port.
If we select DiSEqC1.2/USALS, press ok into the motor interface.
• Transponder: Press ok key to change the current tp.
• Mode: A, Position
A1 Direction: Press
key to move direction to west or east.
A2 Position: set the satellite save position.
A3 Store: save the satellite position to set of A2.
• Mode: B, Drive to Zero; move the cursor to GO, then press OK key, the motor will go to zero.
Press
to set the single satellite setting.