Lagooni Life User Manual

life
special
MANUAL
BACKREST ADJUSTMENTSEATPOSITIONFOOTREST ADJUSTMENTSWING AWAY LEGRESTS ARMRESTSANGULAR ADJUSTMENTANGLE FLIP UP FOOTRESTBRAKES
Loosen the knobs both left and right from
the backrest.
Remove the 4 quick-release pins from
under the seat.
Unscrew the bolts with an Allan key nr. 4
and a spanner nr. 10.
The footrests of the swing away legrests
(life special and junior special) can be
adjust by unscrew the screws by using an
Allan key nr. 4.
Adjust the backrest to a desired position
and tighten the knobs again.
Lift the backrest and seat to a desired
position. Replace the quick-release pins.
Place the footrest in the desired position
and screw it tight again.
For more adjustment of the leg- and foot-
rests, the legrestreceiver on the frame can
be adjusted with an Allan key nr. 4 and
spanner nr. 10.
Slightly lift the armrests to swivel them
around. When placing them back, make
sure the armrests wil be tightened by
pushing them down well enough.
Push the seat max. one pin up on the front
of the seat comparing to the back, to
create an angular adjustment. Replace
the pins at front and push the back down.
The ip up footrests are having the posi-
bility to change the angle. Use an Allan
key nr. 5.
The brakes can be locked or unlocked
by pushing or pulling. The brakes can be
tighten when needed by using an Allan
key nr. 5.

Lagooni Life Specifications

General

Drive Wheel	Rear-Wheel Drive
Type	Electric Wheelchair
Max Speed	6 km/h
Battery	12V 22Ah (2x)
Max User Weight	136 kg (300 lbs)
Weight Capacity	136 kg (300 lbs)
Material	Aluminum frame

Summary

Wheelchair Operation and Adjustments

Backrest and Seat Adjustment

Adjusting the backrest and seat position using knobs and quick-release pins for optimal user comfort.

Armrest Adjustment

Swiveling and securing armrests for user comfort and positioning, ensuring they are tightened properly.

Footrest and Legrest Adjustment

Adjusting the angle of flip-up footrests and the position of swing-away legrests using Allan keys.

Brake Operation and Maintenance

Locking, unlocking, and tightening the wheelchair brakes using an Allan key for safety.

Transport Preparation

Seat and Legrest Removal for Transport

Adjusting the seat to the lowest position and removing armrests or legrests for easier transport.

Backrest Folding for Transport

Loosening backrest knobs, laying it down, and potentially turning it for compact transport.

Wheel Removal for Transport

Pressing quick-release axles to remove wheels, ensuring axles are removed to prevent bending.

Maintenance and Care

General Cleaning Procedures

Regularly removing soap and dirt with soft soap, avoiding caustics like chlorine or alcohol.

Seat and Axle Lubrication

Cleaning the seat and high-low system, and spraying quick-release axles with silicone spray.

Material Care and Lifespan

Handling Neoprene/Platilon with care, replacing the seat after approximately 3 years of use.

Important Transport Notes

Quick Release Axle Handling

Keep quick release axles pressed when removing/replacing wheels to prevent bearing issues.

Wheel Bearing Realignment

Tap bearings in the wheel with a hammer if misaligned to ensure proper wheel replacement.