Need help?Do you have a question about the laguna Series and is the answer not in the manual?
Key safety guidelines to prevent personal injury during operation.
Steps for safely unpacking the machine and initial assembly procedures.
Explains the functions of various buttons on the controller for machine operation.
Procedure for setting the Z axis origin using the automatic tool height adjustment.
Step-by-step guide for manually setting the Z axis origin point.
Routine checks to perform daily for optimal machine performance and longevity.
Common reasons and checks for when the machine fails to power on.
Troubleshooting steps for unexpected machine behavior where it fails to stop.
Addresses problems like the motor not turning or overheating, and their causes.
To Next Page
General