Need help?Do you have a question about the Lake LM 26 and is the answer not in the manual?
General| Battery | No |
|---|---|
| Wireless | No |
| THD+N | <0.001% |
| Limiter | No |
| Display | No |
Essential safety guidelines for operating the device.
Information on compliance with electrical and safety standards.
Meaning of warning and informational symbols used in the manual.
Critical warnings to prevent damage or injury.
Precautions to prevent minor damage or operational issues.
Details on FCC rules for radio frequency interference.
User's obligations regarding grounding and maintenance.
Overview of the Lake LM 26 and its benefits.
Highlights key features and technologies of the LM 26.
Information on Dante digital audio networking capabilities.
Guidance on accessing further product documentation.
Procedure for opening the shipping carton and checking contents.
Guidelines for securely installing the device in a rack.
Information on the forced-air cooling system and airflow requirements.
Details on the device's universal power supply and voltage range.
Instructions for proper grounding and Iso-Float system.
Detailed description of all front panel controls, indicators, and modes.
Description of all rear panel connectors and ports.
Diagram and explanation of the audio signal path within the LM 26.
Integration with Lake Processing environment and software control.
Explanation of processing modules and frames.
Details on IIR and FIR crossover types and configuration.
Methods for storing and recalling module, frame, and system data.
Introduction to the interface, key lock, power, meter, menu, and exit buttons.
Details on LEDs, encoders, mute buttons, and LED metering for I/O.
Explanation of Meter Mode and Menu Mode functionality.
Accessing I/O Config, Frame, Display, and Preset menus.
Description of analog input and output XLR connections and wiring.
Details on AES3 digital audio input/output connectivity and DB25 connector.
Description of primary and secondary network connectors.
Overview of the General Purpose Input/Output connection and pinout.
Connecting the device to AC mains power via the IEC connector.
List and description of fault and warning indications.
Procedures for cleaning the LCD, display, and dust filter.
Default configurations for modules, inputs, and routers.
Definitions of terms, acronyms, and abbreviations used in the manual.
Explanation of gain adjustments at various points in the signal path.
Strategies for maximizing volume and minimizing noise.
Preferential use of digital inputs (Dante, AES3) for quality and latency.
Configuring the digital clocking system for sample rates and sync.
Overview of the LM 26's core specifications and features.
Specifications for sample rate, conversion, data path, and delay.
Specifications for analog inputs and outputs, dynamic range, and frequency response.
Specifications for AES3 digital audio inputs, outputs, sample rates, and termination.
Specifications for Dante network inputs/outputs, sample rates, and topology.
Specifications for the display, meters, mute access, and controls.
Specifications for analog, AES, Ethernet, and GPIO connections.
Specifications for Gigabit and Fast Ethernet ports.
Specifications for GPIO inputs and outputs.
Specifications for voltage, operating range, and consumption.
Device dimensions, weight, and finish.
List of safety and regulatory approvals.
Overview of the product warranty and its terms.
Information on warranty variations by country.
How to obtain technical support and service.
List of registered trademarks and copyrights.
To Next Page
