22
DISHES POSITIONING
It is suitable to place dishes, inside the plastic
basket with the concave side facing upwards.
Place mixed cutlery in a vertical position into the
suitable container minding not to cram them and
whit handgrips towards the bottom (see draw).
CLEANSING AGENTS
Choice of the suitable cleansing agent is an
essential condition if you want to obtain
extremely good washing results as concerns
hygienic results. It is then important to consider
some points. First of all only highly alkaline and
chlorine-active antifoam products, especially
made for industrial dish-washing machines, must
be used and they must be produced by well
known reliable Firms. Mean concentration of the
cleansing agents in powder must be 1,5÷2,5 g/lt.
Mean concentration of liquid cleansing agents
nust be 2÷4 g/lt.
Doser calibration must be done by a supplier's
skilled technician of the cleansing agent.
In order to avoid scales and corrosions, put
cleansing agent above water level on the nearest
area of the sucking pump filter, in this way it will
immediately dilute and will not deposit on the
tank bottom.
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and cups
you must add a surfactant on water (Brightner).
Your cleansing agent supplier's will be able to
suggest the most suitable product. Your machine
is equipped with a rinse-aid dispenser. Mean
concentration used is 0,15 g/lt.
DESCALING
When hard water is used you can find, inside the
machine and also on dishes, calcareous
sediments which must be removed both for
hygienic and operating reasons by a descaling
operation.
Operating process and frequency of this
intervention are suggested by your cleansing
agent supplier who has suitable products,
generally containing phosphoric acid.
In order to avoid damage to the machine do not
increase the quantities and once operations end
rinse abundantly.
SANIFICATION
At last each 30 days it would be useful to do this
operation which guarantees the complete
hygienic conditions of the machine. We suggest
to contact your cleansing agent supplier who will
give you quantity and name of the most suitable
product you can use and that, generally, is an
active chloride powder (100-200 ppm).
In order to avoid damage to the machine do not
increase the quantities and once operations end,
rinse abundantly.
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump automatically starts up at
each cycle to discharge the exceeding water
coming from the rinsing cycle.
In order to completely discharge the tank
it is necessary to perform the following
operations:
1. Switch the machine main switch "A" off;
2. Remove the overflow from the tank;
3. Soon afterwards press the drain pump
pushbutton "R" (the lamp "H" is lighted).
After the water has completely flowed down,
press the drain pump pushbutton "R" to
switch the pump off.
WARNING!
DO NOT FORGET THE PUSHBUTTON
"R" ON "ON" POSITION; THIS CAN
CAUSE DAMAGES TO THE PUMP.
To Next Page
Loading...
