29
PROBLEMS - CAUSES - SOLUTIONS
PROBLEMS CAUSES SOLUTIONS
Main switch is switched off; Turn ON the main switch; The machine doesn't catch
Power plug is not inserted Insert the power plug
Water cock closed; Open water cock;
The Overflow is not in place; Reassemble the Overflow in place
The water doesn't go in
The water inlet hose is blocked Change the water inlet hose
Wrong detergent or dosage Use anti-foam detergent in the right
dosage and never with cold water;
Detergent is inappropriate Use a non-foaming detergent and
never in cold water;
Low temperature in the tank; Wait until the water gets hot and wait
for the achievement of the ideal
temperature indicator light stop
blilnking
Dirty wash filter; Clean filter;
Insufficient Washing
The washing arms are not free to
rotate
Check the presence of obstacles or
the correct positioning of the dishes
Rinsing nozzles blocked; Unscrew and clean nozzles under
running water;
Insufficient Rinsing
Hydraulic pressure lower than 1
bar - 100 kPa;
Wait until the pressure is on or buy a
booster pump;
The dishwasher will not
drain
Drain hose obstructed Check and remove any obstruction
The filter of the drain pump (if
included) is obstructed
Clean the filter of pump suction
Set the dosage according to the
manufacture directions
Check that the dosing tubes are not
blocked
Clean the detergent suction filters
placed in the tanks
The dishes are not dry Rinse-aid has not been used or it
has been used only in small
quantity
Also check the entry of the water from
the mains and clean the filter may be
clogged
On the dishes it forms a
layer
If there is a layer of limestone,
the water is too hard
Check for the presence of operation of
water treatment system external or
embedded
In the case of a film of starch,
high temperatures during the pre-
washing
Not perform manual pre-washing with
temperatures above 30°C
CAUTION! FOR ANY OTHER TROUBLE, CALL SERVICE
To Next Page
Loading...
Need help?
General
