lamber L21-RGB User Manual

27
The drain will stop automatically after 5 minutes (cycle
pushbutton is red).
N.B : the button turns off completely after about 15”
seconds.
To stop manually the drain cycle, press the cycle
button “C” again.
Reinstall the overflow and close the hood.
WARNING! At the end of the drain
operations the cycle pushbutton will be red colour and
will flash slowly, to indicate that the machine is still
powered by the mains.
Disconnect the machine from the mains power
supply by the wall-switch !
CLEANING AND PREVENTIVE
MAINTENANCE
PRECAUTION AND CLEANING
INSTRUCTIONS
-
WARNING! : Before carrying out the
cleaning and maintenance operations,
disconnect the equipment from the mains power
supply:
- Follow the directions on the maitenance in this
guide;
- Wear protective clothing and gloves when
challenged elements are impregned with clearing
solution;
- High temperatures can be reached inside the
machine (90°C). After power supply has been removed,
wait until the machine has reached room temperature,
before working on it.
- Never leave tools, parts or other loose material
in or on the machine;
- Chek that there are no rusting foreign bodies,
because of the material “stainless steel” could begin to
rust. Rust particles can come from non- stainless steel
dishes or damaged wire baskets.
- Do not wash the machine and the area
surrounding it with fire hydrants, steam jets of high-
pressure cleaners;
- When clearing the floor be careful not to
saturate the base of the machine, in order to avoid a
prolonged stagnation of water;
- To clean the inside of the machine, use a brush
or a soft cloth;
- To clean the machine do not use abrasive
cleaners;
- BEFORE starting machine or cycle, after any
maintenance or repair work, make sure all
protectives are correctly installed;
DAILY CLEANING OF THE INTERIOR
OF THE DISHWASHER
- Disconnect the machine by pressing the main
switch "A";
- Remove the overflow pipe and let the
water drain out of the tank (look at the
specific paragraph at the preceding page);
- Wait untill all water is drained and there are no
wastes on the tank bottom;
Once the emptying is completed, indicator “C”
will automatically turn off after about
15”seconds
- Disconnect the machine from the supply mains
by the wall switch;
- Take the filters out and clean them under
running water;
- Re-assemble the removed parts in their
housing;
- Check and clean the washing and the rinsing
jets;
Daily disassemble the lower and upper wash
arms by working on the „big“ ring nut,
like in the picture.
- Clean the outer surface of the machine by
using a wet sponge; do not use water jets
because, besides being dangerous, they could
damage the electrical parts; do not use
abrasive detergents;
- When the machine is to remain unused for a
long time, it’s better to perform the operation
od descaling and sanification.
- To avoid bad smells, leave the hood open.
WARNING . Before carrying
out cleaning the inside of the machine, make
sure that there are no foreign objects that could
damage the rusty steel inside the tank. The
eventual rust particles could come from non-
stainless steel dishes, from baskets or damaged
water pipes not rust-proof.
NEVER WASH THE EXTERNAL PART OF
THE MACHINE WITH A WATER JET

lamber L21-RGB Specifications

General

Brand	lamber
Model	L21-RGB
Category	Dishwasher
Language	English