22
To continue carry a new basket, introduce it in
the machine, close the door and press button
“C”.
ACHIEVEMENTS
Any deficiency in the washing process is
apparent when dirty residuals are visible. An
insufficient rinsing might cause any halos: in this
case, check that the rinsing jets are clean and
there is a sufficient pressure in the water
distribution network.
In the case that residuals are present, check
that:
• the washing jets are clean
• there is detergent
• the pump suction filter is clean
• the positions of the objects in the rack are
correct.
GLASSES POSITIONING
In order to obtain a successful dishwashing, it is
suitable to take care of the way dishes are placed. It
is suitable to place glasses, inside the wire basket
with the concave side towards the bottom. Place
mixed cutlery in a vertical position into the suitable
container minding not to cram them and with hafts
towards the bottom (see the drawing).
S400-ek=MAX 240
S460-ek=MAX 260
S480-ek=MAX 300
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and cups
you must add a surfactant on water (Brightener).
Your cleansing agent supplier will be able to suggest
the most suitable product. Your machine is equipped
with a rinse aid dispenser. Mean concentration used
is 0,15 g/lt.
REGENERATING
(for machines with Water softener)
If the glasswasher is equipped with a Water
softener it is possible to regenerate the resins.
This operation must be done when lamp “E”
is flashing with door open and door closed .
Lift the overflow out of the tank and close the
door .
Push the button "F" fot three seconds until the
lamp "E" is lighted. After twenty (20) minutes
the lamp "E" is OFF.
The regeneration of resins has been completed
automatically and the machine is ready to go into
operation again.
Every 6 days add 1 kg of salt in tablet-form in
the bottle placed on the bottom of the tank.
The flashing-signalling will be signs after 45
washing-cycles.
SALT CONTROL
When it is necessary to add salt in the container, the
“E” lamp blinks quickly.
This operation is programmed to be performed every
10 regeneration cycles.
Unscrew the plug of the salt container at the
bottom of the tank and put 1 kg coarse salt tablets
in it. Clean the gasket and screw the plug.
After having added the salt into the container, perform
the REGENERATION operation by following the
instructions indicated in the previous paragraph.
Attention!
The lack of salt in the container damages the
machine because of limestone, besides a
defective washing of glasses and dishes.
These damages are not covered by the warranty.
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the door of the dishwasher
2. Remove the overflow pipe from the tank;
3 Afterwards push button “F” for 3 seconds.
Alternatively are flashing the control lamp “E” and
the cycle lamp (chosen before)
The discharge will stop automatically after 5
minutes. The control lamps will stop flashing.
Please note: in case the door is open the control
lamp “E” will continue flashing.
Reinstall the flow over and shut the door.