LAMBERT 6D10D200A - Installation and Connection of the Engine

LAMBERT POWER Diesel Engine Operation and Maintenance Manual
11
3
Loctite 242
blue
Apply to bolt thread and bearing surface for
retaining. For example: main oil passage pressure
limit bolt thread
4
Loctite 262
red
Apply to bolt thread surface for lock, sealing. For
example: cylinder head bolt thread part
5
Loctite 275
green
Spread on the surface of pipe and connecting part
for mounting function.
For example: the surface of water outlet heating
device and inlet pipe connection part
6
Loctite 510
red
(orange)
Apply to bight metal surface for dealing.
For example: spread to contact surface between
cylinder and crankcase.
7
Loctite 648
green
Apply to bright metal surface for mounting
function.
8
Loctite 270080
green
Used in plug and hole and apply to oil cavity and oil
pipe.
For example: the surface of all the bowel plug and
cylinder.
3. Installation and connection of the engine
3.1 Lifting of the diesel engine
There is a lifting plate specially for lifting in the front end of cylinder head. When lifting,
keep crankshaft centerline horizontal. It is not allowed to lift aslant or by one side. It should
be slow to lifting and placing. The lifting method figures is as figure 3-1 on the lift.
Figure 3-1 Figure 3-2
3.2 Engine Installation
The output end is at the side of flywheel. When installing with alternator, use elastic