LAMBORGHINI Islero S 400 GT User Manual

Details fluid capacities for cooling system, fuel tank, engine oil, differential, and steering box.

Provides chassis and engine identification numbers and basic specifications.

Lists key engine specifications like cylinder layout, bore, stroke, and cubic capacity.

Specifies intervals for engine oil and filter changes based on mileage.

Outlines the recommended schedule for changing gearbox and differential oil.

Lists essential checks to perform before operating the vehicle.

Step-by-step instructions for starting the engine from a cold state.

Guidance on starting the engine when it is already warm.

Important warnings and common causes for engine starting failure.

Advice on operating the engine correctly after it has started.

Instructions for operating the car's heating and ventilation systems.

Details on adjusting seats and operating the electric window mechanisms.

Procedures for opening the bonnet and accessing the luggage compartment.

Safe and correct method for lifting the vehicle using the jack.

Instructions for safely removing wheels and proper car washing techniques.

Maintenance intervals for greasing and oiling various vehicle components.

Routine checks for water level, engine oil, and tyre pressure.

Specific maintenance tasks to be performed every 300 miles.

Maintenance tasks required at 3,000-mile intervals.

Specifications for valve timing and procedures for setting engine timing.

Description of fuel pumps, filters, and potential causes of fuel starvation.

Step-by-step guide for adjusting the carburettor settings.

Using synchronising equipment for precise carburettor tuning.

Instructions for cleaning and maintaining the air filters.

Details on the vehicle's ignition system, including distributors and coils.

Engine firing sequence and specifications for the ignition distributor.

Guidance on setting and checking the contact breaker gap.

Methods for checking and adjusting the engine ignition timing.

Procedures for cleaning and replacing spark plugs, including gap settings.

Maintenance for the radiator, thermostat, water pump, and system flushing.

Description of cooling fans and the gearbox, including gear ratios.

Details on clutch operation, travel, and propeller shaft maintenance.

Information regarding the vehicle's differential and its ratio.

Specifications for final drive ratios and descriptions of suspension systems.

Details on the steering box and methods for checking/adjusting front wheel alignment.

Procedures for adjusting the vehicle's toe-in and camber settings.

Information on the hydraulic brake system, fluid, and bleeding process.

Specifications for brake pads, wheel balancing, and hub maintenance.

Guidance on suitable tyre types and recommended inflation pressures.

Specifications for brake caliper clamping and disc pad types.

Detailed technical specifications and settings for the vehicle's carburettors.

Essential torque values for tightening engine and drivetrain components.

Summary of engine dimensions, clearances, and firing sequence.

Details on ignition timing, automatic advance, and spark plug types.