6
TEMPERATURE CONTROL AND ADJUSTMENT
LED INDICATORS AND CONTROL PANEL
LED indicators in the front section of your refrigerator are intended to help you in
monitoring the operation of your appliance.
Keep your food in the refrigerator in a safe manner by monitoring and using these LEDs
and controls as explained below:
Fast Freeze Button (1): Use this to freeze food quickly (When you press the fast freeze
button there may be a short delay before the compressor starts to operate. This is normal
and not a compressor fault).
Thermostat Setting Button (2): Used to set your refrigerator between minimum and
maximum values.
Temperature Indicator (3): Displays the inner temperature of your refrigerator.
Orange LED (4): Lights up when the fast freeze button on the LED panel is pressed. In
this case, your refrigerator operates continuously.
Press the button again when the food you would like to fast freeze comes to the desired
temperature and the orange LED will turn off.
Green LED (5): Lights up continuously after plugging in your refrigerator.
Red LED (6): It warns you by lighting up continuously when your freezer is not cold
enough because the door is open for a long time or excessive or too warm fresh food
is loaded for instance.
If the red LED lights up continuously when the conditions stated above do not exist, then
call our Authorized Service.
TEMPERATURE SETTING
The interior temperature of your refrigerator changes for the following reasons;
• Seasonal temperatures,
• Frequent opening of the door and leaving the door open for long periods,
• Food put into the refrigerator without cooling down to the room temperature,
• The location of the refrigerator in the room (e.g. exposing to sunlight).
You may adjust the varying interior temperature due to such reasons by using the
thermostat. If the ambient temperature is higher than 43°C, turn the thermostat button
to maximum position.
To Next Page
Loading...
Need help?
General
