11 / EN
Washing Machine / User’s Manual
Adjusting Rear Feet
• When you turn the knob (visible in the circle)
in the direction of the arrow, the machine
will be elevated by 0.3 mm. When you turn it
in the opposite direction of the arrow, the
machine will be lowered by 0.3 mm.
• You can check your machine‘s rear
and front feet via water level for correct
adjustment.
• Do not adjust the rear feet by using
chargeable devices. Use a screwdriver
instead.
Adjusting the feet with water level
• You must remove the Detergent Drawer to
set the Water Level.
• For the system to operate properly, the
bubble inside the Water Level must be in the
middle.
Electrical connection
Connect the product to a grounded outlet
protected by a 13 A fuse. Our company shall
not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
• If the current value of the fuse or breaker
in the house is less than 13 Amps, have a
qualified electrician install a 13 Amp fuse.
• The voltage specified in the “Technical
specifications” section must be equal to
your mains voltage.
• Do not make connections via extension
cables or multi-plugs.
A
CAUTION!
• Damaged power cables must be replaced
by the Authorised Service Agents.
Electrical requirements
Before you insert the plug into the wall socket
make sure that the voltage and the frequency
shown in the rating label corresponds to your
electricity supply.
We recommend that this appliance be
connected to the mains supply via a suitable
switched and fused socket in a readily
accessible position.
Should the mains lead of the appliance
become damaged or need replacing at any
time, it must be replaced by a special purpose
made mains lead which can only be obtained
from a Authorised Service Agent.
B
WARNING!
• This appliance must be earthed
To Next Page
Loading...
Need help?
General
Weight and Dimensions
