Lamtec MCC User Manual

199
7 Operating Control and Displays
Cold Check
Accessing the cold check (AL1)
Fig. 7-79 Cold check menu with submenus
Performing a cold check
1. In the menu, click ’Cold check’.
The screen for performing a check of the outputs opens.
2. Start the cold check with the ’Start cold check’ button.
3. A dialogue box asks if the cold check mode should be activated: click ’OK’.
NOTICE
If this dialogue box is not confirmed with ’OK’ within a predefined time, the
procedure terminates automatically. The procedure can be repeated immediately.

Lamtec MCC Specifications

General

Manufacturer	Lamtec
Type	MCC
Protection Class	IP20
Communication Protocol	Modbus RTU
Category	Control Systems
Relative Humidity	non-condensing