Lamtec VMS Series User Manual

www.lamtec.de
Sensors and Systems for Combustion Technology
Manual
Fuel/Air Ratio Control System VMS

Lamtec VMS Series Specifications

General

Brand	Lamtec
Model	VMS Series
Category	Control Systems
Language	English

Summary

For Your Safety

Operation

3.16 Integrated O2 Trim

Details the purpose of O2 trim for optimizing combustion and saving fuel.

Settings

4.3 Parameter

Explains parameter access levels, password entry, and changing parameters.

Firing Rate Controller (optional)

5.1 Operation

Covers setpoint entry, operating description, and control modes.

5.1.5 Start-up Sequence

Details the burner's start-up circuit and sequence steps.

5.3 Control Mode

Commissioning

6.2 Function Test

6.4 Adjusting Control Elements

6.5 Programming of Curves

Details procedures for programming fuel/air ratio curves and adding points.

O2 Trim

6.6.1 Automatic Function Monitoring During Operation

6.6.2 Control Strategy

6.6.5 Commissioning

Details O2 trim commissioning, including parameter calculation and modes.

6.6.5.5 Calculation Of Control Parameters

Explains calculation of control parameters like lag time and P-factor.

Tips and Tricks

7.1 Programming 1st Point (Ignition Firing Rate Point)

7.2 Programming While The Burner Is Running

Describes programming procedures while the burner is running.

7.6 Adjusting Firing Rate Individually

System Operation

8.3 Messages / Faults

Covers fault messages, reading faults, and resetting procedures.

8.3.9 Fault Codes

Lists fault codes, restart procedures, and descriptions for troubleshooting.