EN
To clean the transducer:
1) Place 2 to 5 drops of vinegar on the surface and leave for 2 to 5 minutes.
2) Brush the build-up from the surface using a soft brush. Do not use a hard tool to scrape the surface.
3) Rinse the transducer in clean water.
4) Do not use soap or any other alkaline substances to clean the transducer.
To clean the basin unit:
1) Clean the water basin using a soft cloth and vinegar if there is build-up OR calcium deposits inside.
2) If the build-up is covering the safety switch, place a few drops of vinegar on it and clean using the brush.
3) Rinse the basin in clean water.
Storage:
1) Carefully clean and dry the ultrasound humidifier, following the maintenance instructions.
2) Leave to dry completely before storing it away. Do not store away when there is water in the base.
3) Store the appliance in a cool dry place, out of reach of children.
To clean the filter:
a) The demineralising effect and longevity of your filter depends on the mineral content of the water used in the
humidifier. We would like to remind you that it is recommendable to use distilled or demineralised water.
b) Make sure to rinse the filter in clean water every 2 days. To do this, remove it from the tank cap.
PROBLEMS AND SOLUTIONS
In the event of malfunctioning under normal conditions of use, please refer to the following table:
PROBLEM POSSIBLE CAUSES SOLUTIONS
Fan not working, no mist
No electric current Plug in the appliance
Main switch closed Turn on main switch
The water level in the tank is too low Add water to the tank
Leak in the water tank Close the lid properly
Wind, but no mist
No water in the tank Fill the tank
The water level indicator is not in the
right position
Correctly reposition the water level
indicator
The temperature of the unit is too low Put the unit in a room at ambient
temperature for half an hour before
use.
Strange mist smell
Water has been stagnating too long
in the tank
Clean the tank and add clean water
Too little intensity
Too much water in the groove Empty water from the groove and put
the tank back
Mist adjustment is set at a minimum Adjust intensity adjustment knob
Sediment on the transducer Clean the transducer
Water too cold Use water at ordinary temperature
Water is not clean Clean the tank and add fresh water.
Hello Kitty
7
To Next Page
Loading...
