28
Door sealing rubber is deformed
Repair or replace the rubber seal
Door hinges are not loose.
Adjust and fasten the hinges.
Outlet / suction outlet blockage
Fans stop working or operate at low speed.
Ask an engineer for help. Power the refrigerator ON and
OFF. Check the fan and the voltage. If the voltage is
normal, the fan may be damaged.
The door gasket does not seal properly; or door
is opened too often
Use low heat on a hair dryer to make the door seal take
shape.
Gas leakage or cooling system blockage
External
cabinet seems too hot
Ambient temperature is too high, or direct
sunshine
Operating conditions need to be improved
Front grill outlet / suction outlet blockage
Fans stop working or low speed operating
Ask engineer for help, power on the refrigerator, check
the fan whether the voltage is normal or not. If the
voltage is normal, the fan should be damage
Use a soft cloth to clean the water
Reduce the times / frequency of door opening.
The door gasket does not seal properly
Use low heat on a hair dryer to make the door seal take
shape.
7. Data Parameters
compressor with
air-circulated fan
cooling
compressor with
air-circulated fan
cooling
compressor with
air-circulated fan
cooling
compressor with
air-circulated fan
cooling
compressor with
air-circulated fan
cooling
ELECTRICITY
PROTECTION
GRADE
5℃~12℃ or
41℉~54℉
12℃~18℃ or
54℉~64℉
5℃~12℃ or
41℉~54℉
12℃~18℃ or
54℉~64℉
5℃~18℃ or 41℉
~64℉ for the left
zone
4℃~10℃ or 39℉
~50℉ for the right
zone
To Next Page
Loading...