16
The
SELECT BANK [0,1,2] triggers are new with version 3.0 software, and allow a
single emem effect to recall up to three different playbacks per channel. If you have
an effect in Emem 25 for example, register 025 will be recalled on the TDC when
you recall that effect. If you send a Trigger 11 from within that effect, register 125
will be recalled. If you send a Trigger 12 register 225 will be recalled.
Note that these recalls are just like normal register recalls, in that they affect all
channels. Most triggers affect only machines which have valid device numbers, or
are ganged. These do not – they recall the registers regardless of device numbers.
Only machines which have valid inpoints and valid device numbers will be cued.
Starting with version 3.2 firmware, all 300 registers are directly accessible from P-
bus, if the switcher supports this expanded access. This may make the use of
SELECT BANK triggers unnecessary.
The other new triggers are 8 and 9, which are related to Multi-Point Loops. Please
see the detailed operational information section for an explanation of these triggers.
To Next Page
Loading...