Lance TDC-100 - CONNECTOR PIN-OUTS; INTERCONNECT INFORMATION

23
CONNECTOR PIN-OUTS; INTERCONNECT INFORMATION
Connector pinouts for the frame and panel D connectors are listed below.
Connections to the devices are standard RS-422 links.
The connection between the frame and control panel is also RS-422, but includes
power for the control panel. All 9 pins (of the D-9) must be connected, and the
maximum length using #22 conductors is 150’. If the panel must be extended
beyond this length, it should be locally powered. Contact Lance Design for details.
Device A,B, C, D Ports
Pin # Function
1 Ground
2 -RX Data (from device)
3 +TX Data (to device)
4 Ground
5 (no connection)
6 Ground
7 +RX Data (from device)
8 -TX Data (to device)
9 Ground
P-Bus In and P-Bus Loop
Pin # Function
1 Ground
2 Loop to other connector
3 +RX Data(from switcher)
4 Ground
5 (no connection)
6 Ground
7 Loop to other connector
8 -RX Data (from switcher)
9 Ground