Lancia Ypsilon - Page 175

MAIN BEAM HEADLIGHTS
To change the bulb, proceed as follows:
❒ remove cover A fig. 125;
❒ turn the connector unit and the bulb holder B
fig. 127 anticlockwise;
❒ remove the bulb C from connector D and
replace it;
❒ refit the new bulb on the connector making sure
that it is locked correctly, then reinsert the
connector unit and the bulb holder B in
its housing;
❒ then refit the cover A fig. 125.
DIPPED BEAM HEADLIGHTS
To change the bulb, proceed as follows:
❒ remove cover B fig. 125;
❒ turn the snap-fitted bulb holder unit C fig. 128
anticlockwise, remove bulb D and replace it;
❒ refit the new bulb then reinsert the bulb holder
unit C in its housing;
❒ then refit the cover B fig. 125.
fig. 127
L0F0068
fig. 128
L0F0070
173
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX