Land Pride PATRIOT FDR1648 User Manual (English)

Questions and Answers:

J
John SchwartzAug 11, 2025
What to do if my Land Pride Lawn Mower is loading down the tractor?
- R
  Richard LucasAug 11, 2025
  If your Land Pride Lawn Mower is causing the tractor to bog down, ensure you are mowing at the tractor's rated PTO RPM (540 PTO RPM). Also, shift to a lower gear if your ground speed is too fast. If the grass is too wet or tall, wait until it dries or raise the mower's cutting height and cut the grass twice. Clean any debris wrapped around the mower spindles or blades. If the tractor PTO horsepower rating is too low, raise the cutting height, shift to a lower gear, or use a tractor with more horsepower. Consider changing to lower lift blades if they will cut the grass satisfactorily.
M
Melanie HudsonAug 15, 2025
Why does my Land Pride PATRIOT FDR1648 leave patches of uncut grass?
- S
  Sarah BrownAug 15, 2025
  If you notice patches of uncut grass while using your Land Pride Lawn Mower, try mowing at full throttle (540 power take-off rpm) and check the power take-off speed and tractor engine. If your ground speed is too fast, shift the transmission to a lower gear. Check if the blade is damaged or dull, and sharpen and balance or replace it if necessary. Ensure correct belt tension, and if the blade rotation is wrong, install the correct rotation blade.
M
Michael KhanAug 20, 2025
How to fix a slipping belt on my Land Pride Lawn Mower?
- K
  Karen GuzmanAug 20, 2025
  If your Land Pride Lawn Mower's belt is slipping, unplug and clean the mower deck. Remove the belt guard shields and clean the sheaves. Tighten the spring take-up bolt if the belt spring tension is low. If the belt is worn, replace it.
C
christinacraneAug 25, 2025
Why is my Land Pride PATRIOT FDR1648 Lawn Mower vibrating excessively?
- A
  Ashley PattersonAug 26, 2025
  To address excessive vibration in your Land Pride Lawn Mower, replace any bent drivelines and replace any broken or bent blades. Inspect for incorrectly located needles or damaged bearing caps. Remove the belt guard shield and clean debris from the belt area and sheaves. Replace or align damaged or misaligned sheaves. Replace a damaged drive belt, checking for belt contact with the deck component. Remove belt guard shields and clean debris from the belt area and sheaves if there is inadequate clearance between belt guard shields and the belt.
A
Alexa AdamsAug 30, 2025
How to troubleshoot an uneven cut with my Land Pride PATRIOT FDR1648?
- L
  Luis BurgessAug 30, 2025
  If your Land Pride Lawn Mower is producing an uneven cut, shift to a lower gear if your ground speed is too fast. Ensure the mower is level and re-tension the belt. Sharpen dull blades and balance them, or replace them if necessary.
D
Deborah WoodSep 4, 2025
What to do if my Land Pride PATRIOT FDR1648 Lawn Mower blades are scalping the grass?
- R
  Robert ZimmermanSep 4, 2025
  If your Land Pride Lawn Mower blades are scalping the grass, raise the cutting height by adjusting the wheels. If there are ridges in the terrain, change the mowing pattern. Reduce speed on turns.