EasyManua.ls Logo

Landis+Gyr Gridstream IV Series User Manual

Landis+Gyr Gridstream IV Series
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598
Certification Exhibit
FCC ID: R7PCONCS4
IC: 5294A-CONCS4
FCC Rule Part: 15.247
IC Radio Standards Specification: RSS-210
ACS Report Number: 10-0097.W06
Manufacturer: Cellnet Technology Inc.
Model: Series-4 Conc.
Manual

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Landis+Gyr Gridstream IV Series and is the answer not in the manual?

Landis+Gyr Gridstream IV Series Specifications

General IconGeneral
CategoryNetwork Hardware
Product SeriesGridstream IV Series
Operating Temperature-40°C to +70°C
TechnologyRF Mesh
Frequency902-928 MHz
SecurityAES 128-bit encryption
DimensionsVaries by model
WeightVaries by model
Standards ComplianceFCC

Summary

Certification Exhibit

Chapter 1: Preface

About the Landis+Gyr Gridstream Network

Describes the Gridstream AMI network architecture and components.

About the Concentrator

Details the hardware components of the Gridstream Concentrator.

About This Guide

Outlines the content and purpose of the user and installation guide.

Who Should Use This Guide

Identifies the intended audience for this manual.

Contacting Technical Support

Provides contact information for technical assistance.

General Inquiries

Information for general questions and sales inquiries.

Chapter 2: Pre-Installation

Safety Overview

Outlines essential safety training and responsibilities for installers.

Pre-Installation Checklist

Lists critical items and tasks to prepare before installation.

Chapter 3: Field Configuration

Required Tools

Lists the necessary tools and equipment for field configuration.

Chapter 4: Concentrator Installation

Antenna Mounting Options

Describes different methods for mounting the concentrator antennas.

Wood Pole Mount Installation

Details the procedure for installing the concentrator on wood poles.

Metal Pole vertical Mount Installation

Details the procedure for installing the concentrator on metal poles.

Chapter 5: RF Filter Enable/Disable and Battery Replacement Kit

Enable/Disable RF Filter

Procedure to enable or disable the integrated RF filter.

Battery Test

Instructions on how to test the concentrator battery.

Chapter 6: Performing System Upgrades

Accessing a Concentrator for Programming

Explains methods to access concentrators for upgrades.

Upgrading a Concentrator Over the Air (OTA)

Details the process for remote firmware upgrades via OTA.

Chapter 7: Troubleshooting

Verifying Configuration

Steps to verify concentrator network configuration and communication.

Appendix A: Product Specifications

General Specifications

Lists key physical and operational specifications of the concentrator.

Appendix B: Compliance

FCC Class B

Information regarding compliance with FCC Class B digital device regulations.

RF Exposure

Details compliance with FCC RF exposure limits.

Appendix C: Bench Testing

Testing Concentrators

Explains the process for testing concentrators, including configuration and verification.

Configuration

Details the steps for configuring concentrators for testing.

Verification

Describes the procedure for verifying concentrator operational status.

Appendix D: About Firmware

CC9C Serial Port Configuration

Explains the serial port configuration for the CC9C module.

Diagnostics Mode

Details the concentrator's diagnostics mode and its functionalities.

Appendix E: About Programming and Diagnostic Cables

Update Cables

Lists cables and their capabilities for system upgrades and configuration.

Appendix F: Sample Survey Sheet

Sample Survey Sheet

Provides an example of a survey sheet used during configuration.

Appendix G: Power Cable Installation

Power Connection and Termination

Describes proper methods for connecting and terminating power cables.

Glossary

Index

Related product manuals