Thank you for your purchase of the 8 Ft. Firewood Rack
with Cover. At Landmann USA, we strive to provide
you with an easy to use, easy to assemble product.
Should you have questions, issues, a defective part or if
you have any questions concerning its use, please
contact us at: customerservice@landmann-usa.com
-OR-
1-800-321-3473 M-F 8-5 Eastern Time
Proof of purchase may be required.
Landmann® Limited
Distributed by Landmann® USA
Cartersville, GA 30120
www.landmann-usa.com
Made in China
© 2012 Landmann USA
8 FT. FIREWOOD RACK with COVER
PARTS LIST
PART DESCRIPTION QUANTITY
A SIDE FRAME
2
B BOTTOM FRAME 4
C CROSS BAR 3
D 2.9 IN. BOLT
12
E LARGE WASHER 12
F LARGE HEXNUT 12
G
COVER
1
ASSEMBLY INSTRUCTIONS
A Phillips screwdriver and an adjustable
wrench are needed for assembly.
Assembly time: 15 minutes
For easiest assembly, follow the assembly steps in this order.
1
STEP
Assemble the side frames [ A ] and
(4) bottom frames [ B ] as shown
inserting a cross bar [ C ] between
each assembly point. Use (2) 2.9
IN. bolts [ D ], large washers [ E ]
and large hexnuts [ F ] at each
assembly point. Tighten bolts
securely.
2
STEP
Place cover [ G ] on firewood
and rack. Make sure the
cover straps are securely tied
around both the side frame
leg [ A ] and the bottom
frame [ B ].
The door flap has 6 straps.
Tie these straps with the
cover straps to keep the
door flap closed.
READ FIRST!
RULES FOR SAFE USE
• USE THE FIREWOOD RACK ONLY ON FLAT SURFACES.
• THE FIREWOOD RACK IS RECOMMENDED FOR USE ON
A HARD SURFACE SUCH AS A CONCRETE PATIO OR
GRAVEL.
• CAUTION! IF USED ON AN UNSTABLE SURFACE, THE
FIREWOOD RACK MAY TIP OVER.
• CAUTION! DO NOT DROP OR SLAM WOOD IN THE
FIREWOOD RACK.
• CAUTION! DO NOT MOVE THE FIREWOOD RACK ONCE
WOOD HAS BEEN LOADED.
G
TIED
COVER
STRAPS
VER. 5, 7/23/2012
Assembly and Use
Instructions for Model:
82434
D
E
F
C
A
A
B
B
D
A
B
To Next Page
Need help?
General
