What causes shoulder tread wear on both shoulders of my Landoll Utility Vehicle tires?
Shoulder tread wear on both shoulders of your Landoll Utility Vehicle tires is caused by: * Under inflation. Increase inflation to the correct PSI. Check axle alignment. * Overload. Loads are above rated tire capacity. DO NOT load above rated tire capacity.
What to do if I experience vibrations while driving my Landoll Utility Vehicle?
If you experience vibrations while driving your Landoll Utility Vehicle, consider the following potential causes and solutions: * Improper tire inflation: Inflate to the proper pressure. * Tires cupped or have flat spots: Replace the tires. * Wheels bent or loose: Replace or tighten them. * Tires incorrectly mounted: Remount them. * Mud in wheels: Clean the wheels. * Tire(s) out of balance: Balance the tires. * Brakes dragging: Locate the cause and repair. * Object(s) stuck between duals: Remove the object(s).
What to do if the brakes are not working or are intermittent on my Landoll 825E Utility Vehicle?
If the brakes are not working or are intermittent on your Landoll Utility Vehicle, it could be due to: * An improperly connected brake air system. Reconnect the hand valves properly. * A plugged relay/emergency valve. Clean the valve. * A defective tractor protection valve. Repair or replace it. * A restricted tubing or hose line. Locate and eliminate the restriction. * A broken line. Locate the break and repair it. * A tractor air system failure. Troubleshoot the tractor air system and repair it.
Why do my lights flicker on my Landoll Utility Vehicle?
Lights flicker on your Landoll Utility Vehicle due to: * Shorted or loose wires. Locate, insulate, replace, or tighten the wires. * Grounding through the fifth wheel. Locate the broken ground wire on either the tractor or semitrailer.
What causes shoulder tread wear on only one shoulder of my Landoll 825E tires?
Shoulder tread wear on only one shoulder of your Landoll Utility Vehicle tires is caused by: * Axle damage. Straighten or replace the axle. * Axles not parallel. Check axle alignment.
What causes a cylinder to leak on a Landoll Utility Vehicle?
A cylinder leaks on your Landoll Utility Vehicle because: * Seals are worn or damaged. Replace them. * The rod is damaged. Replace it. * The barrel is damaged. Replace it.
What causes a Landoll 825E to track to one side?
A Landoll Utility Vehicle tracks to one side due to axle alignment issues. Re-align the axle.
What causes a Landoll 825E to track to either side?
A Landoll Utility Vehicle tracks to either side due to: * Broken or bent springs or equalizers. Replace the defective parts. * Axles not parallel. Re-align the axles.
What causes lights to be dim on my Landoll 825E Utility Vehicle?
Lights appear dim on your Landoll Utility Vehicle due to: * A voltage difference between the semitrailer and tractor. Match the bulbs with the tractor voltage. * Grounding through the fifth wheel. Locate the broken ground wire on either the tractor or semitrailer.
What causes uneven brakes on a Landoll 825E?
Uneven brakes on your Landoll Utility Vehicle can be caused by: * A restriction in the hose. Locate the restriction and remove it. * Worn brake linings. Reline the brakes. * Grease on the linings. Reline the brakes. * A broken slack adjuster. Replace the slack adjuster. * A leaking brake chamber diaphragm. Replace the diaphragm.
General| Brand | Landoll |
|---|---|
| Model | 825E |
| Category | Utility Vehicle |
| Language | English |
To Next Page
