Why does my Landworks GUO003 Tools power head start, then stop?
If the Landworks Tools power head starts and then stops, it could be due to a low battery. Try charging the battery. Alternatively, the battery might be too cold. In this case, remove the battery and place it in a warm location, such as inside a jacket pocket, a vehicle, or a small cooler with a warmer.
What to do if Landworks GUO003 Tools power head will not start but the battery is fully charged?
If the Landworks Tools power head won't start even with a full charge, the battery might be too cold. Remove the battery from the unit and place it in a warmer environment. For example, keep it inside a jacket pocket, vehicle, or a small cooler with a warmer.
What to do if Landworks Tools auger head gets stuck when drilling?
If the Landworks Tools auger gets stuck while drilling, this may be due to hitting large rocks or roots. Remove the obstruction or drill in a different location. Also, the overload protector may stop the unit if you push down too hard. Reduce the downward pressure and allow the head to spiral drill down naturally.
Why does my Landworks Tools unit stop working after the beep when drilling?
If the Landworks Tools unit stops working after a beep when drilling, it's likely that the overload protector has been activated because you are pushing down too hard. Release all the triggers and buttons, wait for 3 seconds, and then try again. Reduce the downward pressure and let the head spiral drill down naturally.
Why is my Landworks GUO003 Tools auger cutting slowly?
If the Landworks Tools auger is cutting slowly, the blades may be dull and you should replace them with new blades.
Why does my Landworks GUO003 auger jump on ice?
If the Landworks Tools auger jumps on the ice, the blades may be damaged or sharpened incorrectly. Replace them with new blades.
Instructions for attaching the auger assembly to the power unit using a bolt.
Steps for inserting and removing the lithium-ion battery from the power head.
To Next Page
General