SE AT TLE
50
MOUNTING
1° PASSAGE
1. Check the levelling of the shower tray
with the level.
2. Lay the profiles on the wall and use the
level for plumbness.
3. Drill the holes in the wall with a pencil.
4. Drill the holes in the wall with the drill.
5. IMPORTANT: Only install the wall profile
on the side where the door closes defini-
tively on the wall, as it would be hidden
by the magnet profile.
Note: On the fixed glass side, insert wall
plugs in any case for subsequent steps.
1
2
3
5
4
A
A
8*30
To Next Page
Loading...