Need help?Do you have a question about the Laney HCM30 and is the answer not in the manual?
General| Reverb | Yes |
|---|---|
| Technology | Solid State |
| Type | Combo Amplifier |
| Power Output | 30 Watts |
| Speaker Size | 10" |
| Controls | Gain, Treble, Middle, Bass, Reverb |
| Inputs | 1 x 1/4" Instrument Input |
| Outputs | Headphone Jack |
| EQ | 3-Band EQ (Bass, Middle, Treble) |
| Channels | 2 (Clean and Drive) |
Key precautions for operating and maintaining the amplifier to prevent hazards.
Information on potential hearing loss from high noise levels and OSHA limits.
Pre-operation checks, plug conformity, and initial setup procedures.
Connect guitar and set clean channel volume level.
Engage and set distortion level for the crunch channel.
Control overall output and activate scooped EQ boost.
Adjust low, mid, and high frequencies for tone shaping.
Control reverb, connect audio sources, and use footswitch.
Connect external speakers or headphones; isolates internal speaker.
Connect bass guitars with passive or active pickups.
Adjust compression for punchy sound and activate the compressor.
Shape tone by adjusting bass, mid frequency, gain, and treble.
Set volume, connect audio, or use DI for PA/recording.
Connect external speakers or headphones; isolates internal speaker.
To Next Page