Need help?Do you have a question about the Laney IronHeart IRT-Pulse and is the answer not in the manual?
Warning against opening the unit and advises servicing by qualified personnel.
Advises against exposing the appliance to rain or moisture and to read instructions.
Conformance to CE, Low Voltage, EMC, RoHS, and WEEE directives.
Guidance on environmentally sound disposal of the product at its end of life.
Feature to route a dry recorded signal through the IRT-PULSE for re-amping.
Connection point for the instrument, requiring a high-quality cable.
3.5mm stereo jack for headphones, stereo feed to recorder, amplifier, FX unit, or PA.
Balanced 6.35mm jack output for connecting to the next item in the signal chain.
Connects to a Laney FS1 footswitch to bypass the unit.
Input for backing tracks from CD/MP3 players or other line-level devices.
Connection for the included DC power supply unit (PSU) only.
Connector for recording/replay via USB, compatible with various systems.
Contains safety information and serial number location, advising to note the serial number.
Controls for overdrive, output level, and additional gain boost.
Features like DARK, BRIGHT, EQ, and EMULATION for sonic adjustment.
Enables signal bypass and remote switching via footswitch.
Setup guide for headphone use, including initial settings and connecting a backing track.
Setup guide for connecting to an amplifier, including initial settings.
Allows routing of a dry recorded signal through the IRT-PULSE for re-amping.
Carries the direct, unprocessed guitar signal for potential re-amping.
Carries the fully processed guitar signal, with or without emulation.
Advice on moving, warming up, and cooling down tubes to prevent damage.
Factors affecting tube life, signs of deterioration, and common preamp tube issues.
Instructions for qualified service engineers to safely replace tubes.
To Next Page
General
