Need help?Do you have a question about the Laney IRONHEART IRT-SLS and is the answer not in the manual?
Guitar input jack and the pre-boost circuit for increased gain.
Controls for Lead Gain, Lead Volume, Rhythm Gain, and Rhythm Volume.
Bass, Middle, Treble EQ with pull switches and the Tone control.
Selects channels and adjusts amplifier output power (300W/60W).
Reverb control and tube warm-up/ready indicator.
Mains power inlet, power switch, and safety precautions.
D.I., USB, Phones, and Aux connectors for output and input.
Insert FX loop for external processors and DIN/jack for footswitch control.
Speaker output connectors and impedance selector switch for speaker load.
Example of connecting the D.I. output to a mixing console or stage monitor.
Details functions controlled by the Laney FS4-IRT footswitch.
Overview of USB capabilities including recording and re-amping.
Instructions for recording audio and re-amping guitar tracks via USB.
Integrating external effects pedals into the USB re-amping workflow.
Recommended control settings for achieving a clean guitar sound.
Recommended settings for rhythm guitar tones.
Settings for achieving rock and metal guitar tones.
Recommended settings for detuned metal guitar tones.
Guidelines for safely handling and cooling vacuum tubes.
Procedure for replacing tubes, to be performed by qualified engineers.
Statement regarding compliance with FCC Part 15 rules.
Simplified EU declaration of conformity for radio equipment.
To Next Page
General
