Need help?Do you have a question about the Laney LC15 and is the answer not in the manual?
General| Type | Tube |
|---|---|
| Channels | 1 |
| Output Valves | 2 x EL84 |
| Reverb | Yes |
| Power Output | 15W |
| Speaker | 1 x 10" |
| Controls | Treble, Middle, Bass, Volume, Reverb |
| Inputs | 1x 1/4" |
| Preamp Valves | 3 x 12AX7 |
Details permissible noise exposure levels to prevent hearing loss, with a table of duration vs. sound level.
Instructions for unpacking, checking the plug, and connecting the amplifier, including wiring conventions.
Describes the function and use of the HI and LO input sockets for connecting instruments.
Explains how the GAIN control adjusts preamp overdrive and distortion levels for different tones.
Details the BRIGHT SWITCH function, adding sparkle to upper frequencies, most noticeable at low gain.
Describes the BASS, MIDDLE, and TREBLE controls for adjusting the preamplifier's frequency equalization.
Explains the VOLUME control, which sets the overall listening level of the amplifier.
Information on power fuses, their purpose, and the importance of using the correct type and rating.
Details the HT FUSE role in protecting the DC power, emphasizing correct replacement.
Describes the LINE OUT socket for preamplifier output at a nominal OdBu level.
Instructions for connecting an external speaker cabinet, noting impedance requirements.
Explains the REVERB FOOTSWITCH connection for optional reverb control.
Details the FX RETURN and FX SEND sockets for integrating external effects units.
Tips on warm-up time, room placement for bass response, and avoiding wall obstruction for ventilation.
Guidance on choosing HI/LO inputs and the effect of the BRIGHT SWITCH on tone.
Addresses common issues like no power, no sound, and repeated fuse blowing, with solutions.
Illustrates the valve layout (V1-V5) and the function of each valve in the amplifier circuit.
To Next Page
