L5-STUDIO USER MANUAL - EN
www.laney.co.uk
10
Re-Amp Facility: During recording the amplier processed signal is sent to the right hand
channel. The left hand channel carries the guitar signal totally unprocessed. On an iPad
using Garage Band if the track is recorded in stereo then copied with one track panned
left and the other track panned right, then both raw and processed signals are available
independently.
This allows for the re-amplifying of a sound that may have been over processed initially. To
re-amp via Garage Band on the iPad, solo the original channel and record a new one with
the link in place from the rear re-amp socket and the guitar input. The newly processed
signal will now appear on the right channel with the guitar direct signal again on the left.
Other effects may be added into the link cable but the guitar original sound will not be
recorded. It will instead record to the left channel the sound directly after the effects with no
amplier and the fully processed signal after the amplier and effects on the right.
To Next Page
Loading...
Need help?
General
