-7-
6.4 Remove the Authorized Number
(
or you can overwrite with another number you wish to change it).
E.g.: if you want to remove the authorized number at position 12, and the password is 1234, then you
can send 1234#TEL#012#
6.5 Setup allow all calling in numbers can access it
Tips: This command allows anybody calling the SIM number to access it.
Warning! With the above command you allow free access to anybody calling!
6.6 Setup only authorized number can access it (Default)
Tips: With the above command you allow only people that are in the authorized number list can
access the RTU5024. This is the standard and recommended option.
Inquiry this setting:
Reply: Allow all numbers can access it or Allow User Numbers can access it only
6.7 Setup the relay close time
Tips: Thetimeshouldbein0~9.5seconds.
This command is useful in case you need to keep the relay closed (or button pressed) longer. The
default time is 0.5 econds(500 ms). You can change it with the GOT command. The relay closed time
is twice as the number you set, E.g.: if you set pwd#GOT19#,meanstherelayclosed
19/2=9.5Seconds.
To check the value, you can use the command pwd#GOT? , the unit will reply the current value.
If you want to let the relay always closed until you call it next time, then you can set the time as 00,
the format is pwd#GOT00#, the relay will be always closed until next time call in. in this case, only
the authorized number can access it. The other unauthorized numbers can not access the unit. This is
pwd#TEL#Serial Number#
pwd#AU#
pwd#AA#
pwd#AC?#
pwd#GOTTime#
To Next Page
Loading...